If you are using stabilizer that has adhesive, please be sure to remove the needle and clean between every pattern with rubbing alcohol. If you are using stabilizer that has adhesive, remove the needle and clean between every pattern with rubbing alcohol. Make sure you're using correct and enough stabilizer for the fabric you are working with. The combination of the needle size, thread size and fabric could be incorrect.Ī. Be sure to use the correct size needle and thread for the type of fabric that you are sewing.ĩ. Cranberry Dental Studio has provided exceptional dentistry to Cranberry Township and the surrounding community since 1980. The tension should be adjusted when you change fabric or thread type.Ī. Make sure that your feed dogs are in the correct position.Ī. If your stitches are close together or just piling up on the stitch plate, use the stitch length adjustment key to lengthen your stitch.ī. Press the plus side of the stitch length adjustment key to make your stitch longer.Ĩ. Specialties: Cosmetic and Family Dentistry, Neuromuscular Dentistry, Veneers, TMJ treatment, Implant restoration, Invisalign, Zoom and KoR Whitening, Migraine Therapy Established in 2005. If your machine is an embroidery machine, check that the tension is set at 5. If your machine is an embroidery machine and you are creating an embroidery design, make sure that you are using the Q foot.ĥ. The tension could be too tight or too loose.Ī. Set the tension to the basic thread tension setting or adjust the tension manually. Make sure that the pressure foot you are using is correct for the type of stitch you have selected. Replace the bobbin with a new one to test and see if this could be the issue.Ĥ. Remove the bobbin and make sure the bobbin is inserted and threaded properly in the shuttle race.ī. Remove any loose threads or lint in the shuttle race by using the brush instead of blowing into the machine.Ĭ. Make sure that there are no scratches or burrs on the bobbin case (if so, it will need to be replaced).ĭ. Make sure you are using the correct size bobbin that was designed for this machine.Į. The bobbin thread may not be wound properly. If your machine is an embroidery machine and you are using metallic thread, cone shaped or cross threaded spools of thread, be sure to use a spool net around the spool of thread.Ī. ![]() If so, remove the thread completely from the machine and re-thread it.ī. Make sure you're usin g the correct size spool cap for the size of the thread spool. ![]() Check to make sure that the upper thread was threaded properly through the thread path and that it isn't tangled. ![]() The thread doesn't match the needle type (refer to manual).Ī. The selected pressure foot is incorrect. The top thread or bobbin hasn't been set correctly.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |